Pre-Wired Evil-T Bars for 2011-2020 Low Rider

  • Sale
  • $399.99
  • Regular price $499.00
SKU: DIGA2EVSB12PO


OUR PRE-WIRED EVIL-T BARS FOR THE 2011-2020 LOW RIDER COME IN A VARIETY OF SIZES RANGING FROM 12" TO 16". AVAILABLE IN GLOSS BLACK OR THE HIGHEST QUALITY CLASSIC CHROME. 

When we introduced our Evil-T Bars for the Harley-Davidson Dyna, Softail, and Sportster our goal was to combine classic styling and unique attitude for owners that want the best quality with no compromises. Ride comfort and easy installation make choosing Dominator Industries handlebars to customize your bike a no-brainer.

With the Harley-Davidson Sportster (2014-2021), Dyna (2012-2017) and Softail models (2011-2021 , Street Bob, Low Rider/ S, Heritage, Deluxe, Slim & Fat Bob) the ability to purchase “prewired” bars is typically expensive. The wiring for your stock switches is hardwired into your controls and doesn’t allow for the same solution that is available for the touring models.

We have designed a solution that is extremely simple and far less expensive. Allowing you to use our “Prewired” bars with your existing switches and turn signals.

Our bars come with the control and turn signal extensions Pre-Wired along with self-solder/heat shrink connectors.

You simply cut your control and turn signal wires, strip a small portion of each, place them into our pre-soldered/heat shrink connectors and shrink them.

We've done the hard work for you, leaving only the finishing touches up to you! Really it’s just that simple! In addition it’s much more cost effective! The cost of your control and turn signal extensions (and TBW if needed) is well over $100.

With our Prewired solution you get fully extended harnesses. No additional extensions necessary! Also you will not have to look at the bulky extension connections that typically show when installing harness extensions on your bike. Finally an all in one, prewired solution for your softail or sportster that won’t break the bank!

Total width 28 inches, pullback 2.5 inches

    All of our parts are hand-made in the USA employing a multi-step manufacturing process using the finest materials. Tube diameter is 1.25” stepped down to 1” for stock/conventional controls. Both grips have 0.5” x 2”, laser cut slots for internal wiring. The throttle side is honed out and notched for fly by wire but also fits cable throttle systems. Laser cut tubing yields the smoothest corners with no slag for easy wiring. The Knurled Center for non-slip grip on our handlebars is engineered to be a direct custom replacement for stock equipment.

    Customer Reviews

    No reviews yet Write a review

    Liquid error (layout/theme line 189): Could not find asset snippets/sb-car.liquid